[bold]

Select bold/emphasized text when printing. The bold command can be used anywhere in a line of text, causing all subsequent text to be printed with a stronger, bold version of the current font.

Parameters

Currently, two parameters are supported, with no parameter values required. Only a single on or off parameter should be provided, mixing parameters will cause undefined results.

Parameter	Description
on	Set subsequent text printing to use the bold version of the current font.
off	Set subsequent text printing to use the standard version of the current font.

Note, the [bold] command switches the bold/emphasized effect off by default, therefore the command sequences [bold] and [bold: off] are equivalent.

Example

• Markup
• Output at 58mm
• Markup 80mm

This is a simple markup example, using only the [barcode] and [cut] commands.

Bold Text example

This is Standard Text.
[bold: on]This is bold text.
This is still bold.
[bold: off]This is standard text again.

It is safe to [bold: on]use bold on [bold] and off on the same [bold: on]line [bold]freely.

[cut]\